Honda Accord Axle: Repair Tips, and Maintenance Guide

Performance is the trademark of the Honda Accord. In order to transfer power from the transmission to the wheels, the axle system is essential. For a smooth and secure driving experience, the axle components especially the Constant Velocity axles need to be properly maintained and repaired on time. Firstly let’s understand the Honda Accord Axle then we will move towards the maintenance tips of CV axle.

Understanding Honda Accord CV Axle

The CV axle is made up of joints that enable the wheels to receive power while allowing the vehicle steering and suspension to move up and down.

The condition of these joints may worsen with time. The damage to their protective boots could lead to pollution and oil leaks, in particular.

This is what the CV axle is now let’s moving towards the tips to maintain it, so your Honda Accord can run smoothly.

Tips to Maintain Honda Accord Axle

Regular Inspections

• Check the rubber boots for leaks, rips, and cracks on a regular basis. If damaged boots are not repaired right away, joint failure may result.
• When turning, listen for any popping or clicking noises that could be signs of a deteriorating CV joint.

Driving Habits

• Steer clear of quick twists and aggressive acceleration as they can put more strain on the CV joints.
• To avoid putting too much strain on the axle components, drive carefully over uneven terrain.

Timely Repairs

To avoid more issues, take quick action to address any axle wear or damage.

This is how you can maintain the CV axle in Honda Accord but if there is a case that it requires repairing then you can do it by yourself, in few easy steps:

Repairing Honda Accord CV Axle

It might be time to replace the Honda Accord Axle if you see any strange noises or vibrations that indicate a deteriorating axle. An outline of the replacement procedure is provided below:

• First you need to park your vehicle on a flat surface and apply the parking brake.
• Now, you can use a jack to lift your car and secure it with jack stand and then take out the wheel that goes with the axle that needs to be changed.
• Unscrew and loosen the axle nut using the socket and breaker bar.
• To enable the steering knuckle to move, remove the lower ball joint and, if required, the tie rod end.
• Remove the axle from the wheel hub with caution. Being careful not to harm the transmission seal, pry the axle’s inner end from the intermediate shaft or transmission.
• Next, you must install the replacement CV axle by pushing it into the transmission until it clicks into position. Reassemble the suspension parts and line up the outer end with the wheel hub.
• As directed by the manufacturer, torque every bolt and nut. To guarantee correct installation, lower the car, reinstall the wheel, and take a test drive.

Also Read: How to Fix Flashing check Engine Light

In The End

In summary we conclude that axle is a crucial component in Honda accord and you should maintain it on timely basis. Here in this Blog we have shared the steps to replace or repair your Honda Accord Axle.